1. Convenient Storage Design: Optimized layout for easy organization and centralized management of electronic hydrometers.
2. Embedded Wireless Charger: Place the hydrometer in the main compartment to activate charging mode.
3. Sleep Compartment Design: Side compartment for idle hydrometers, automatically triggering sleep mode to save power.

1. File Download Link:

1. 3D Model: Click to Download STL File

2. Recommended Printing Parameters:

1. Material: PETG (heat-resistant, corrosion-resistant)
2. Layer Height: 0.2mm
3. Infill Density: 15%
4. Printing pauses at layer 195 for embedding 15*4mm magnets.

Tip: Optional to remove the pause at layer 195, but magnets will not be embedded.

1. Assembly Steps:

1. Embed the wireless charging module into the reserved slot in the dock.
2. Connect the Type-C power cable to a 20W charger.

2. Charging Operation:

1. Place the hydrometer in the main compartment; red light indicates charging, green light indicates fully charged.
2. Idle devices placed in the side compartment will automatically enter sleep mode within 60 minutes.

1. Charger Compatibility: Supports 20W Type-C wireless chargers (input voltage 5V/9V).
2. Printing Material: Avoid using PLA as it may deform in high-temperature environments.
3. Device Compatibility: Only compatible with Cuckoo electronic hydrometers; modifications required for other brands.