Table of Contents

Initial Device Setup

[2026 Cuckoo Ben BLE2]

Step 1: Activation & Connection

1. Activate the Device

  1. Place the device on a flat surface and quickly bring a magnet close to the reed switch 3 times (each trigger within ≤3 seconds; the green light will stay on upon success).

2. Connect to Device Hotspot

  1. Name: `CuckooTilt` 
Note: The device is only used for configuration at this stage and has no internet connection.

Step 2: Configure WiFi

1. Access Configuration Page

  1. Enter `192.168.4.1` in your browser.
  2. Select the WiFi network and enter the password .

2. Copy Device ID

  1. Click Click To Copy to copy the unique device ID. 
Warning: This ID is the device binding credential; do not share it.

3. Save Configuration

  1. Click Save, and the device will restart and connect to WiFi.

Bind Device to Account

Step 1: Register & Log In

1. Register an Account

  1. Visit ckbrew.com to complete registration.

2. Add Device

  1. After logging in, select “Add New Device”.
  2. Enter the copied device ID and choose a color label. 
Tip: The color is only for interface identification and does not affect functionality.

Notes

  1. Signal Stability: The recommended distance between the device and router is ≤5 meters.
  2. Fault Recovery: If configuration fails, repeat Step 1 to reactivate.
  3. Backup Network: If the primary WiFi disconnects, the backup WiFi will automatically activate after 20 seconds.
  4. First Charge: Use a 20W Type-C wireless charger for 5-8 hours.